Before we talk about sump pumps we need to describe what it is supposed to do. The purpose of a sump pump is to remove storm water or flood water from your home.
A sump is a low space that collects liquids. It is also referred to as an infiltration basin used to manage surface runoff water. The most common location of all sumps is the lowest point in a basement or crawl space, into which flows water that seeps or is piped in from the outside. If water is regularly flowing into this sump a pump is added to move water outside and away from the foundation.
In areas where homes are more subject to heavy amounts of hydration or in jurisdictions where required, a perimeter drain tile is added underground around the foundation. This drain tile is directed into the sump pit or crock. The drain tile is, in most cases, perforated and will allow excess water at the foundation to enter the system before it has the opportunity to seep in through the foundation.
Sump Pit or Crock
The sump pit is a basin at the lowest part of the basement or crawl space where the perimeter tiles terminate into. This basin is placed deep enough to allow the drainage pipe to fully evacuate all of the collected water and to not allow water to hold in the pipes. Allowing water to hold in the pipes will keep unnecessary
moisture against the foundation and provide for a damp feeling space and a potential for mold growth. These drain pipes are extended into the pit far enough to create a well-sealed union. If the drainage pipe do not extend into the pit there will be a high likelihood or opportunity to have the extra hydration erode under the foundation or not be fully collected.
The Sump Pump
A pump is placed in the pit. There are two basic types of sump pumps; submersible and pedestal. The submersible pump is a fully contained electric pump placed at the bottom of the pit. The pedestal pump has the impeller or pump placed at the bottom of the pit while the motor is above the pit and up in the air. Both pumps should operate or activate automatically. The system should operate without fail and without any human contact. If the system has to be manually operated the risk of failure will be very high. In order to operate automatically there has to be some form of switch. The two most common switches or float activated and pressure activated. The float is a very common method. Within the pit there is a floating device this has a tilt sensor. If the float rises to pre-set level it will activate the pump and allow it to remove all of the water from the pit. If it is a pressure system the level of water above the sensor causes the switch to activate the pump. Regardless of which type of pump and which type of sensor is used there should always be a back-flow or check valve installed in the discharge pipe above the unit. This prevents any discharge water from dropping back into the pump at the conclusion of the pumping cycle.
Common Issues and Failures with Sump Pumps
The sump pumps do fail. The most common life span of a sump pump is seven years. The drain tiles can become clogged with debris or root intrusion. The float activation should be monitored. Water in the pit should never be allowed to become high enough to enter back into the drain tiles. But, the most common issue with a sump pump is the easiest to predict. Without power the pump is not operate. To fully protect your foundation or your home consider installing some form of alternative power to operate you sump pump.
Quick Facts about Electric Heaters
- Most have a statistical life span of 7 year.
- Most pumps are constructed of either a plastic or cast iron cover.
- The average cost to purchase a new pump can be as low as $100.00.
- A sump pump can be installed between $300.00 and $2000.00 with the average cost across the country being $1,024.00.
- Most homeowners never test their sumps pumps and do not know they are malfunctioning until a catastrophe has already occurred.